when did morris guitar stamp serial number on headstock

Ultra glossy and no scratches what-so-ever. Waited another 2 days for the lacquer to harden further and hit it with 3M Scratchout, Maguire's clearcoat safe liquid compound and finally a thin coat of Techwax. The finish is knocked back to an acceptable thickness without sanding through the lacquer or the decals. At this point, the decals are buried in the lacquer with no edges or bubbling visible. Each successive coat 'melts' into the previous one if done correctly.įinally, allowed 8 days for the lacquer to out gas before final sanding & polishing (the 320 - 1000 grit wet/dry sandpaper and another treatment with the Micromesh polishing kit).

Again, allowing about 30 minutes between each, and each coat wetter than the previous one. Then shot 4 more coats of the Behlen clear. Remasked the neck, headstock sides & back and shot 8 coats of progressively wetter clear coats, allowing 30 - 45 minutes between coats.Īgain, allowed to gas out 3 days and wet sanded with 320, 400 & 600 grits till the decaled areas were level with the surrounding area (before sanding, you will clearly see a difference in the clear coat where the decals lay). You HAVE to make sure the decals are applied PROPERLY!), I allowed them to dry for 24 hours. Once the decals were in place (making sure there were no bubbles or air trapped under them or you get a condition called 'silvering' and no amount of gloss will get rid of it. That brought up a really high gloss that was my base for applying the decals. Remember to plug any holes in the headstock or the water will make the wood swell). If you lay the neck flat, the lacquer is pretty much self leveling, which saves considerable time.Īllowed 3 days to gas out and then hit it with the same 320, 400, 600, 800 & 1000 grit papers used wet. Much more than a mist coat will result in a brown, not 'vintage' color) followed by 2 light coats of Behlen clear lacquer (allowing about 30 minutes between coats) and finally a fairly wet coat of the clear.

Then a very light misting of Behlen Star Amber Vintage tint (a little goes a long way with this stuff. Yes, you can sand it out with rolled sandpaper, but the risk of marring the headstock I spent all that time on was more than I wanted to take a chance on. You don't want the finish building up in there. I also masked the inside of the tuner holes. I then masked off the fingerboard, neck, sides & back of the headstock. Using a hand sanding block, I started with 320, 400, 600, 800 & 1000 grit wet/dry sandpaper. I started by removing the old decals & finish from the headstock.

When did morris guitar stamp serial number on headstock